Connector, Male SCART or JP21, 21-Pin

21-Pin Male Plug Connector kit for use with SCART (EuroSCART) or JP21 (Japan RGB 21-Pin) cables.

Optional Retro Access exclusive custom-designed Printed Circuit Board (PCB) for DIY cables. The Sync Stripper option features an integrated LM1881 circuit for clean, reliable, pure CSync.

This is for destination cables only into a switch, display or upscaler, not for use as a SCART source.

SCART PCB Installation Instructions:

1. The strain relief fits up to 7-8mm OD cable, and will require drilling and deburring for use with Mini-Coax.
2. Slide the strain relief over the cable jacket.
3. Verify orientation and solder the PCB to the SCART connector.
4. Solder Red, Green, Blue conductors to R, G, B pads.
5. Solder Sync, Left Audio, Right Audio conductors to S, LA, RA pads.
6. Solder 5V conductor to the round VIN pad.
7. Solder grounds to square ground pads.
8. Sync Stripper Only: For TTL (5V) sync, bridge jumper JP202. Use caution as closing this jumper violates SCART specifications and may damage consumer grade equipment.
9. Install the SCART shield, use glue for jacket strain relief and assemble the housing.

JP21 PCB Installation Instructions:

1. The strain relief fits up to 7-8mm OD cable, and will require drilling and deburring for use with Mini-Coax.
2. Slide the strain relief over the cable jacket.
3. Verify orientation and solder the PCB to the SCART connector.
4. Solder Red, Green, Blue conductors to R, G, B pads.
5. Solder Sync, Left Audio, Right Audio conductors to S, L, R pads.
6. Solder 5V conductor to the round +V pad.
7. Solder grounds to large unlabeled ground pads.
8. Install included thru-hole resistor, solder in place and clip legs.
9. Install the SCART shield, use glue for jacket strain relief and assemble the housing.