Retro Access exclusive custom-designed Housing (Hood) and Printed Circuit Board (PCB) for DIY cables. Unlike conventional designs which place components downstream at the SCART end, Retro Access boards place key signal components right at the source (console). This ensures superior signal integrity for the clearest, most accurate audio-visual experience. This kit includes all necessary circuit components pre-mounted for safe and specification compliant RGB video while aiding in clean, simplified assembly versus struggling with loose components.
Compatible with the PlayStation 1 AV Multi Out only.
Cable selection is for the strain relief hole size only, cable is not included. The approximate diameter of Fortraflex is 7mm (0.27″), Coaxial is 9mm (0.35″).
Installation:
- Remove the plastic retainer at the rear of the AV Multi Out connector.
- Remove pins 3, 6 and 7 and reinstall the plastic retainer.
- Using the lower housing as a fixture, solder the board pads to the connector pins.
- Solder Red, Green, Blue lines to R, G, B pads.
- Solder Right Audio, Left Audio lines and Sync to R, L, S pads.
- Solder 5V to the round 5V pad.
- Optional GunCon: Solder signal to GunCon pad, and ground to GND. Drill a hole in the shell to accommodate the RCA cable.
- Solder grounds and shield drain where applicable to square GND pads.
- Use glue for jacket strain relief and assemble the housing.
Please contact a modding professional if you are not comfortable building DIY cables.
Features:
- Premium Tantalum caps on the RGB lines.
All product names, logos, and trademarks, registered or unregistered, are the property of their respective owners. They are referenced on this site solely to identify compatibility. Their use does not imply any affiliation with or endorsement by those companies.
